Bacteriostatic water, sterile water, and the 0.9 per cent that makes the difference

Reconstitution is the point at which a stable product becomes a perishable one, and the change is not incremental. Deamidation, hydrolysis and disulphide exchange all require water as a participant or a medium; aggregation requires molecular mobility that the dried matrix denies. Adding two millilitres of diluent restores all of it at once. The consequence is that a product with a two-year shelf life as a cake may have an in-use period measured in weeks, and the second figure is not derivable from the first by any calculation.

Aggregation, and the method that dissolves the evidence

Aggregation covers a range of species from soluble dimers to visible particles, formed by covalent routes such as disulphide scrambling or by non-covalent association of partially unfolded monomers. For peptides the process is often nucleated at an interface — the air-water interface of a shaken vial, the silicone oil layer on a siliconised stopper, the ice-water interface formed during freezing — which is why mechanical handling and freeze-thaw cycling matter as much as temperature.

The analytical difficulty is severe and specific to the trade’s chosen method. Reversed-phase chromatography runs in an acidic, partly organic mobile phase which dissociates most non-covalent aggregates before or during separation. The aggregate is loaded and the monomer is detected. Size-exclusion chromatography under non-denaturing conditions separates by hydrodynamic volume and reports high molecular weight species directly; analytical ultracentrifugation and light scattering methods characterise them further. None of these is offered as a routine service to this market.

The consequence for a reader is that the aggregate content of a research vial is, at present, an unmeasured quantity. It is not necessarily a large one — well-made lyophilised peptides are frequently very low in aggregate — but no certificate in circulation addresses it, and the purity figure that is printed instead is generated by the one method guaranteed not to see it.¹

What makes a method stability-indicating

A stability study is only as good as the analytical method behind it, and the requirement has a name: the method must be stability-indicating, meaning it must resolve the parent compound from its degradation products and quantify the change. Establishing that is done by forced degradation — deliberately stressing the material with acid, base, oxidant, heat and light — and demonstrating that the resulting products are separated from the parent and from each other with adequate peak purity.

Almost nothing sold as a purity determination in this market has been validated that way. A generic peptide gradient run for twelve minutes may perfectly well resolve the parent from its two largest process impurities and entirely fail to resolve it from its isoaspartate isomer or a closely related oxidation product. The number it returns is a purity figure, not a stability measurement, and using a series of such figures to argue that a product has not degraded is a category error.

The compendial guidance on analytical validation is explicit about specificity, and about demonstrating it against the degradation products the molecule can actually form. The gap between that expectation and practice in this trade is not a matter of dishonesty. It is that the method being sold was designed for a different purpose and is being asked a question it was not built to answer.²

In-use stability, and where the numbers come from

In-use stability is established by a dedicated study: the finished product reconstituted as intended, at the intended concentration, in the intended container, stored at the intended temperature, sampled at intervals, and analysed by stability-indicating methods for related substances and by a size-based method for aggregates. The output is a period, and the period belongs to that formulation in that container and to nothing else.

The in-use periods circulating in this market are not derived that way. They are, in the Journal’s experience of tracing them, borrowed from the labelling of marketed pen presentations, which are different formulations at different concentrations with different preservative systems in different primary containers. Marketed in-use periods for the incretin pens run from four weeks to eight depending on product and storage condition, and none of those figures transfers to a reconstituted research vial by any argument we can construct.

What can be said generally is directional rather than numerical. Degradation in solution proceeds orders of magnitude faster than in the cake. Lower temperature helps substantially. Repeated warming and cooling of an opened vial is worse than steady storage. Preservative-containing diluent addresses microbial growth and does nothing about chemical degradation. And in the absence of a study on the actual product, any specific number quoted for an in-use period is an assumption wearing a specification’s clothes.

One further loss is routinely mistaken for degradation. Peptides adsorb to glass and polymer surfaces, and the relationship runs the awkward way: the more dilute the solution, the larger the proportion a given surface area removes.³

Bacteriostatic water, sterile water, and what each is for

Sterile water for injection contains water and nothing else. It is sterile when the container is opened and it has no capacity to remain so, and it supports the growth of any organism introduced subsequently. It is the appropriate diluent for a single-use presentation and the wrong one for anything intended to be entered more than once.

Bacteriostatic water for injection contains benzyl alcohol at nine parts per thousand. Benzyl alcohol inhibits microbial growth, which is what makes a multiple-dose presentation coherent, and it is important to be exact about what that means: a preservative suppresses the proliferation of organisms introduced during use. It does not sterilise a contaminated solution, it does not act instantly, and its effectiveness against a given organism is established by a specific compendial test rather than assumed.

Two further points get lost. Benzyl alcohol is not universally compatible; it has been implicated in the aggregation of certain protein formulations, and compatibility with a given peptide is a question for data rather than for convention. And a preservative system has its own stability: preservative content declines over an in-use period, which is one of the attributes a proper in-use study measures. A diluent choice is therefore a formulation decision with chemical consequences, not a matter of preference between two clear liquids.⁴

Freezing a solution is not storing it

Freezing a reconstituted vial to extend its life is a common inference and a poor one, for reasons that have nothing to do with temperature and everything to do with what happens during the phase change. As ice forms, solutes are excluded from the crystal lattice and concentrated into a shrinking unfrozen fraction. Local concentration, ionic strength and pH in that fraction can shift dramatically — buffer components crystallise at different points, and a phosphate buffer is notorious for a large pH excursion on freezing.

The ice-water interface is itself a denaturing surface, and interfacial area increases with the number of freeze-thaw cycles. Each cycle presents the peptide with a fresh opportunity to unfold at that interface and aggregate. This is why formulations intended for frozen storage contain cryoprotectants and why lyophilisation exists as a technique at all: the point of drying is to avoid keeping a peptide in a partially frozen aqueous system.

The Journal states the mechanism and declines the recommendation, as this department’s practice requires. What can be said without advising anybody is that freezing a reconstituted solution is a different chemical operation from freezing a dried cake, that its effects are formulation-dependent and not predictable from first principles, and that no in-use study we have seen in this market has examined it. A reader treating the freezer as a pause button is relying on an assumption nobody has tested for that product.

What twenty companies document, and what they do not

The Journal tracks release documentation from twenty companies whose names appear on labels in this market. On stability the picture is close to uniform. All twenty state a storage condition. Nineteen state a shelf life. None reports residual moisture as standard. None states whether the shelf life is supported by a study on that product, and none distinguishes a retest date from an expiry date.

Where practice differs it is worth naming. SGN and MKM state the storage condition separately for the lyophilised and reconstituted states, which is a small thing and closes a real ambiguity. KP and HJ ship in amber glass. QST provided, on request, the conditions and duration of a study on one product, which is the only such document we have received. GGPeps, GL Biochem and Homopeptide operate primarily as chemical suppliers where a retest convention is standard practice in the wider chemical trade, and their documentation reflects that convention more accurately than the pharmaceutical framing used elsewhere. TFC, JEEP, QSC and ERP answered part of our questionnaire; several others did not reply.

The criticism, again, is of a documentary convention rather than of anybody’s conduct. No company named here has been shown to us to have misstated a result. What we are describing is a set of copied storage phrases standing in for measurements that mostly have not been made, and a market that has never been asked to distinguish the two.

A note on method and sourcing

The regulatory framework in this article is taken from the harmonised guidelines on stability testing and on biotechnological products, read in the original, and from the current compendial chapters on storage definitions, distribution of temperature-sensitive products and stability in dispensing practice. The degradation chemistry is drawn from the peptide and pharmaceutical sciences literature, and where a claim is a generalisation across sequences this piece says so, because sequence dependence is the rule rather than the exception.

The shipment data is ours. Nine parcels, ordered at catalogue prices as ordinary customers, with calibrated loggers placed inside the insulated payload and sampling at five-minute intervals. Eight complete traces and one truncated by a customs hold. We disclose that nine parcels is not a survey, that we did not control the packing operation, and that a single logger cannot characterise a payload with a thermal gradient across it.

Nothing in this department is a recommendation about storing, reconstituting or administering anything. The compounds discussed are sold for research use only and are not approved for human use in any jurisdiction. Corrections and disputes go to standards@compoundjournal.com; documents, traces and certificates readers would like examined go to letters@compoundjournal.com, and we do not identify the source of anything sent to us.

The finding the Journal least wanted and most trusts is that the transit excursions everybody worries about are probably not the largest exposure in this supply chain. A dried cake at low moisture tolerates a warm afternoon. A reconstituted vial in a refrigerator door for six weeks, with no in-use study behind the number that justified the six weeks, is a different proposition, and it attracts almost no attention at all.